Search | Intex Support

291 results found for your search term: „QX2600 Sand Filter Pump & Saltwater System (220V) (26680)“

Intex product user manual QX2600 Sand Filter Pump & Saltwater System (220V), 26680

User manual, in which you will find all important information on using your Intex product. QX2600 Sand Filter Pump & Saltwater System (220V), 26680

The following results contain only part of the search terms:

Saltwater System Without Filtration

The solinator cannot operate without the filtration on because it does not have its own pump to pump the water. If it is connected to the filtration with the solinator, it automatically switches on with it. Without filtration it will remain idle and display a water flow error.

Sand in the water

Sand in the water after a cartridge change usually indicates insufficient backwash. It is important to set the valve correctly and include a "RINSE" step to help settle sand in the filtration vessel and prevent it from escaping into the pool.

Can I use sand from the playground or sand from the beach in the sand filter pump?

No, this sand contains impurities and does not have the correct grain size, which can lead to improper filtration function. Use only the recommended filter sand available from pool equipment stores. Use of improper sand may damage the system and void the warranty.

Sand filter pump, saltwater system - power shut-off, timers

After a power failure, most INTEX sand filters and solinators restart the last program set. Older filtration models from 2019-2020 will not save the program. The use of a timer is technically possible, but INTEX does not offer it.

Saltwater systems – error 90

An error 90 on a solarator indicates poor or no water flow. If the solinator is properly wired and filtration is running correctly, then the venting, filter media, water level, compatibility of all equipment, electrode and flow sensor should be checked.

Will the saltwater system work without the filtration running?

No, a saltwater system will never work without filtration. The saltwater system does not have its own pump to draw water from the pool. It is essential that the saltwater system is connected BEHIND (AFTER) the filter pump and that the filtration is on. If the saltwater system is turned on without filtration, the saltwater system will not turn on and most likely an error message 90 (insufficient water flow) will appear. At the same time, however, the saltwater system will not be damaged, it will just remain idle and not produce chlorine. If you have the filter pump with built-in saltwater system, the saltwater system will automatically switch on the filtration.

I bought a filter pump with a built-in INTEX saltwater system, but I don't want to use a saltwater system. Is it possible to run the pump to filter the water without the saltwater system?

Yes, you can set the pump to work individually.

Can I use the saltwater system with a small pool?

You can use the saltwater system with any pool where you also use a filter pump that draws water from the pool. Without the filtration, the saltwater system will not work. The saltwater system does not have its own pump, it must be connected in the system behind the filter pump. When selecting a saltwater system, always follow two parameters: the maximum water volume for which the saltwater system model is designed and the pump power/flow rate that the saltwater system needs.

Release air for the Sand filter pump

When venting the sand filtration, first turn off the filtration. Then put the lever in the "N" position and release the vent valve. Close it again as soon as water starts to flow out. Unscrew the cap on the outlet or hose at the top. As soon as water starts to flow, screw it back on. Put the lever in the "filtration" position and switch on the filtration.