Search | Intex Support

20 results found for your search term: „Multi-colored Battery Operated Led Light (28503)“

The following results contain only part of the search terms:

Transom Motor

The transverse marine electric motor requires a traction or semi-traction battery, ideally gel or AGM. The recommended battery capacity is 65-75 Ah, allowing operation for up to 5 hours at lower speeds. The charger should have switching between battery types or automatic charge cycle control.

What type of battery do you recommend for the Intex 68631 motor?

We recommend either a traction battery with a deep discharge cycle or a semi-traction battery. Preferably a gel or AGM Marine type battery (contents will not leak when tipped over). Recommended capacity 65 - 75 Ah (approx. 2hrs at max power). The battery charger should have the ability to switch for Gel, AGM, Normal batteries or be equipped with a microprocessor automatically controlling the charging cycle depending on the type of battery.

Can the battery of the ZR100 (28626) be replaced?

The battery is not replaceable, it is sealed inside to prevent water from reaching it and causing a short circuit. The body of the vacuum cleaner with the battery cannot be opened. If the battery does not work, the whole vacuum cleaner body (without accessories) must be replaced.

Can the battery of the ZR200 (28628) be replaced?

The panel on the hot tub beeps and cannot be operated.

The hot tub motor base with panel needs to be serviced.

Is electric or battery power required for the LED pool sprayer?

No. The LED light is powered by a hydroelectric generator, so no additional power source is required.

Can I use the Intex LED light in a different environment?

No, the Intex LED light is designed exclusively for above ground pools with PVC walls. Use in other environments may not be safe or functional.

Can I use the Intex LED wall light in in-ground pools?

No.

Why is there no light on the saltwater system display?

There are several reasons why the light is not on. 1. The system is in power saving mode. Press any key to display the last code on the LED display. 2. The device is without power. Make sure the cable is connected properly. Unplug the cable, wait a few seconds, and then plug it back in. 3. Make sure the cable to the electrode is connected properly. 4. If the device does not respond, the display may be faulty.

Can the outer part of the wall light (outside the pool) be submerged in water and is it waterproof?

The outer part of the wall light is waterproof against splashing water and rain, but it is not designed to be submerged in water. If you submerge this part in water, you will void your warranty.