Search | Intex Support

18 results found for your search term: „Magnetic LED Pool-wall Light (100-240 V) (28698)“

Intex product user manual Magnetic LED Pool-wall Light (100-240 V), 28698

User manual, in which you will find all important information on using your Intex product. Magnetic LED Pool-wall Light (100-240 V), 28698

The following results contain only part of the search terms:

Does the Intex wall light require special tools, drilling or cutting the pool wall to install?

No. The Intex Wall Light does not require any special tools, drilling or cutting of the pool wall. The wall light uses magnetic waves to generate power and hold itself in place. The location of the wall light can be changed quickly and easily without tools or damage to the pool wall.

Can I use the Intex LED light in a different environment?

No, the Intex LED light is designed exclusively for above ground pools with PVC walls. Use in other environments may not be safe or functional.

Can I use the Intex LED wall light in in-ground pools?

No.

Why is there no light on the saltwater system display? What should I do?

There are several reasons why the light is not on. 1. The system is in power saving mode. Press any key to display the last code on the LED display. 2. The device is without power. Make sure the cable is properly connected. Disconnect the cable, wait a few seconds and reconnect it. 3. Make sure the cable to the electrode is properly connected. 4. If the device is not responding, the display may be malfunctioning.

Can the outer part of the wall light (outside the pool) be submerged in water and is it waterproof?

The outer part of the wall light is waterproof against splashing water and rain, but it is not designed to be submerged in water. If you submerge this part in water, you will void your warranty.

Is electric or battery power required for the LED pool sprayer?

No. The LED light is powered by a hydroelectric generator, so no additional power source is required.

Can I also use the Intex floating light in inground pools?

Yes.

The SERVICE light on the filter pump is on. What should I do?

If the SERVICE indicator is continuously lit, it is most likely a circuit board failure. The solution is to replace this board or the entire motor base. If the unit is under warranty, claim it from your dealer. If the SERVICE indicator is flashing, moisture has probably gotten into the circuit board. We recommend that you allow it to dry by flipping the saltwater system or filter motor base with the saltwater system over for 4 hours and allowing it to dry in the sun. The equipment should always be placed on a wooden base. Do not place filter pumps and saltwater systems in grass or anything similiar.

What to do if the O3 generator light is on?

If the O3 GENERATOR indicator on the ozone saltwater system is lit, it indicates a motor malfunction. The product should be claimed from the dealer if it is still under warranty. If it is not under warranty, the entire motor base has to be replaced.