Protection against spam bots. Please answer the following question: What year is it this year?
156 results found:

Connecting the filter pump
Correct connection of the cartridge filtration is essential for its efficient operation. It is important to observe the height logic of the hose connection as well as the correct positioning of the pump below the water level. Improper extension of the circuit reduces the pressure and efficiency of the device.

Backwash for the Sand filter pump
Backwashing is important to maintain proper pressure and cleanliness of the filtration system. The procedure varies depending on the valve type - 4-way and 6-way - and ensures effective cleaning of newly placed sand.

Bleeding the cartridge filter pump
Too much air in the filtration system reduces water flow and can cause noisy operation or filtration malfunction. Venting is accomplished by turning the vent valve until water begins to escape. After proper venting, the filtration can be turned back on.

Cartridge Filters – Basic Troubleshooting
The main problem with cartridge filtration is insufficient water flow. This can be caused by poor maintenance, mechanical failure and poor wiring. It is necessary to check the cartridge and the entire water circuit in which the filtration is connected.

Cartridge gauge
The new C1000 and C1500 cartridge filtration models are equipped with a cartridge wear indicator. The colour indication shows the condition of the filter - green indicates clean, yellow indicates the need for cleaning and red indicates the need for replacement or thorough cleaning.

Codes 91 and 92
Error E91 indicates low salt content, while E92 indicates too high. To achieve the correct concentration, the salt must either be added evenly or reduced by partial water change. The key is to dissolve consistently and check the values against the recommended tables.

High/low pressure in Sand filter Pumps
Pressure problems in the sand filtration can be caused by improper installation, the presence of air bubbles, or contaminated filter media. Low pressure is often related to inadequate system venting, while high pressure indicates the need for backwashing. Proper positioning of the pump below the water level is also important.

Hoses and connecting to other Intex products
The connection of the pool to the filtration depends on the diameter of the hoses and the type of accessories. The overview of compatible hose adapters and connection options for various INTEX pool and filtration combinations will facilitate correct installation, including skimmer mounting and the use of adapters A and B.

Leakage at the hose(s)
Water leakage from hoses is often caused by an improperly fitted o-ring. Simply gently slide it into the groove and connect the hose carefully. If it still does not leak, replacing the clamp will help. The simple instructions provide a step-by-step procedure.